|Place of Origin:||China Baoji|
|Model Number:||2.5inch ID 3inch ID 4inch ID|
|Minimum Order Quantity:||1|
|Packaging Details:||Wooden Box|
|Delivery Time:||3-4 weeks|
|Supply Ability:||1 set 3 weeks|
|Name:||Wireline Pumping Tee Wireline Pressure Control Equipment||Material:||Alloy Steel&Nickel Alloy|
|Function:||Be Used To Connect The Wellhead Manifold To Provide A Path For Large Flow||Work Pressure:||5k 10k 15k|
Wireline Pumping Tee,
BOP Pressure Control Pumping Tee,
Wireline Pumping Tee 15k
The Wireline Pumping tee is attached below the BOP,The Wireline Pumping tee connection
thread is used to connect the wellhead manifold to provide a path for large flow. NPT thread
hole on the other side of the tee body is a pressure release valve . After installing the pressure
release valve, it can be used for pressure relief to ensure safe operation.
II. General Technical Parameters
|Bore||Work Pressure||Service||Connection||Seal Dia.|
|2.5＂||5K 10K||Std H2S||4-3/4＂-4ACME||3.75＂|
|3＂||15K||Std H2S||7＂-5STUB ACME||4.375＂|
The Pump in tee is composed of a body, a nonunion plug, a nonunion nut (standard part),
a slip and a nonunion nut.The body is a pressure member, and the material is 4140,
Through forging, tempering treatment, mechanical properties test and ultrasonic testing,
to ensure that meet the requirements of use.The nut and the slips are fixed by the top
wire and play the connecting role.
1.1．Insert the seal into the hole on the body.
1.2. Place the union plug on the sealing washer, then put the union nut (standard part)
on the body, tighten the thread, and then install the thread plug on the union plug and
1.3 Installt the O-ring into a slot at one end of the body；
1.5 Place two slips on the outer circle of the body；
1.6 Screw on the union nut；
1.7 Tighten the two jacking wires respectively；
1.8 Install the plug on the body and tighten it.
1. Install the pressure test connector and connect the pressure test line；
2. Start the pressure test pump to carry out the pressure test. Refer to the specific specifications and
drawings for the test pressure and time. Fill in the test record card.
Ⅵ. Daily Maintenance
1．After use, the O-ring and seal should be replaced；
2．When not in use, should take the protector and brush the thread with anti-rust oil for storage.
Welcome to contact us at any time.
Contact Person: Selina Qiang
Tel: 86 13571793445