|Place of Origin:||China Baoji|
|Model Number:||2inch 2.5inch 3inch 3.5inch 4inch 5inch|
|Minimum Order Quantity:||1|
|Packaging Details:||Wooden Box|
|Delivery Time:||2-3 weeks|
|Payment Terms:||T/T, Western Union|
|Supply Ability:||1 set 2 weeks|
|Name:||2.5 Inch GU Connector Wireline Pulling Tool||Size:||2inch 2.5inch 3inch 3.5inch 4inch 5inch|
|Material:||Alloy Steel&Nickel Alloy||Fish Neck:||1.375inch 1.75inch 2.313inch 3.125inch|
|Actual OD:||1.81inch~||Fishing OD:||1.375inch~2.61inch|
JU Connector Wireline Pulling Tool,
2.5 Inch GS Pulling Tool,
Nickel Alloy Wireline Pulling Tool
GU Connector is used in connection with GS pulling tool, and they form GR Pulling Tool.
II.Technical parameters of common specifications
|Szie||Actual OD||FN||Fishing OD||Connection||Lower connection thread|
Technical parameters can also be according to user requirements
III. Structural characteristics:
GR pulling tool is mainly composed of GS pulling tool (1) and GU Shear Up Adaptor (2), as
shown in the attached assembly drawing.
During fishing operation (refer to GS assembly drawing), when the fishing claw (8) touches the
mouth end of the inner fishing neck, it will retreat and fall into the slightly smaller diameter of
the core (9) and be retracted; When the fishing claw (8) completely enters the inner fish neck,
the fishing claw (8) is immediately opened to catch it under the thrust of the compression
auxiliary spring (5). If the tool is blocked upwards, it can be shaken off.
IV. Disassembly and assembly:
1.1 install shear pin on GS pulling tool first;
1.2 punch out the shear pin (6) on GU Shear Up Adaptor with a punch;
1.3 Screw off the hexagon socket set screws with flat point (5) on the coupling nut (4) with an Allen wrench;
1.4 flush the cylindrical pin (3) and remove the upper joint (1);
1.5 the vice clamps the coupling nut (4), the pipe wrench clamps the fish neck of the GS pulling tool (5), and
the coupling nut (4) is removed;
1.6 remove the GS fishing device GS pulling tool (see the operating instructions of GS pulling tool for steps).
1. When assembling, the threads must be coated with grease;
2. External burrs or scratches of all parts shall be leveled with a file.
1. After the tool is disassembled, check the damage of each component and replace the
2. When assembling, apply a thin layer of grease on the thread surface.
3. After assembly, the fishing neck is attached with thread protector and marked for later use.
Welcome to contact us at any time.
Contact Person: Selina Qiang
Tel: 86 13571793445